Adding Margins (Margin Shift) - Sharp DX-C311 Operation Manual

ADDING MARGINS (Margin Shift)

This function is used to shift the copy image right, left, up or down to adjust the margin.
This is convenient when you wish to hole punch the copies.
Shifting the image to the right so the copies can be bound at the left edge with a string
Place the original.
Place the original face up in the document feeder tray, or face down on the document glass.
1
After placing the original, specify the original size.
☞
ORIGINAL SIZES
Select the special modes.
(1) Touch the [Special Modes] key.
2
(2) Touch the [Margin Shift] key.
☞
Special modes menu (1st screen)
(1)
Special Modes
Margin Shift
Down
3
Right
Up
(page 2-29)
(page 2-40)
(2) (3)
OK
Cancel OK
Left Side 1 Side 2
1/2 1/2
(0~1) (0~1)
inch inch
Not using margin shift
1
The punch holes cut off
part of the image
Set the margin shift.
(1) Touch the margin shift position.
Select one of the 4 positions.
(2) Set the amount of the margin shift with
.
0" to 1" (0 mm to 20 mm) can be entered.
(3) Touch the [OK] key.
You will return to the base screen of copy mode.
2-43
COPIER
Using margin shift
1
The image is moved to
allow space for the holes
so the image is not cut off.
Contents