Sharp DX-C311 Operation Manual page 672

Problem
Printing does not take
place.
Color printing does
not take place.
Two-sided printing
does not take place.
Point to check
Is the I/O timeout setting too short?
Was a Notice Page printed?
Have functions been disabled by the
administrator?
Is the color mode set to "Color"?
Have functions been disabled by the
administrator?
Does the paper type setting of the
selected tray specify a type of paper that
cannot be used for two-sided printing?
Are you using a special size or type of
paper?
Have functions been disabled by the
administrator?
If the I/O timeout setting is too short, errors may occur
while writing to the printer. Ask the administrator of the
machine to configure an appropriate time in "I/O Timeout".
➞ System Settings (Administrator) > "Printer Settings" >
"Interface Settings" > "I/O Timeout"
A Notice Page will be printed to indicate the cause of the
problem if a print job cannot be performed as specified
and the cause is not shown in the display. Read the
printed page and take appropriate action.
For example, a notice page will be printed in the
following situations.
• The print job is too large to fit in memory.
• A function that has been prohibited by the
administrator is specified.
By factory default, Notice Pages are not printed.
When user authentication is enabled, the functions that
you can use may be restricted in your user settings.
Check with your administrator.
Select "Automatic" or "Color" for the color mode setting.
The color mode setting is configured as follows:
Windows:
On the [Color] tab of the printer driver.
Macintosh:
In the [Color] menu of the print window.
In Windows, [Black and White Print] can also be
selected on the [Main] tab of the printer driver. If you
wish to print in color, make sure that the [Black and
White Print] checkbox on the [Main] tab is not selected
.
When user authentication is enabled, the functions that
you can use may be restricted in your user settings.
Check with your administrator.
Check "Tray Settings" in the system settings.
If the [Disable Duplex] checkbox is selected
two-sided printing using that tray will not be possible.
Change the paper type setting to a type that can be
used for two-sided printing.
➞ System Settings > "Paper Tray Settings" > "Tray
Settings" > "Change"
For the paper types and sizes that can be used for
two-sided printing, see "SPECIFICATIONS" in the
Maintenance & Safety Guide.
Some functions may have been disabled in the system
settings (administrator). Check with your administrator.
When user authentication is enabled, the functions that
you can use may be restricted in your user settings.
Check with your administrator.
8-13
TROUBLESHOOTING
Solution
,
Contents