Installing External Power Option - Emerson TopWorx 4310 Instruction Manual

Instruction Manual
D103391X012
6. If you are replacing the power module see the additional steps to reset the power module remaining life counter, in
the Resetting Power Module Variables procedure found on page 41.
7. Close the cover and tighten the instrument cover screws.
Figure 2. TopWorx 4310 Wireless Position Monitor with Battery Sourced Power Modules
J1 PWR TERMINAL
HART
TERMINALS
COVER SCREWS
W9640
Figure 3. Power Module
J1 PWR
TERMINAL
W9645

Installing External Power Option

Refer to figure 4 and 5 when installing the wiring.
1. Loosen the two instrument screws and open the cover.
2. Install the cable gland assembly O-ring on the cable gland threads; push it on as far it will go, as shown in figure 4.
J2 GND
TERMINAL
POWER
MODULES
J2 GND TERMINAL
ELECTRICAL CONNECTION SCREWS (4 TOTAL)
MECHANICAL MOUNTING SCREWS (4 TOTAL)
4310 Wireless Position Monitor
December 2011
7