Emerson TopWorx 4310 Instruction Manual page 17

Instruction Manual
D103391X012
2. Install the mounting bracket on the actuator.
3. Attach the wireless position monitor to the mounting bracket using the 4 mounting bolts, as shown in figure 12.
4. Check for clearance between the magnet assembly and the positioner feedback slot.
5. Once the instrument is mounted perform the local interface calibration procedure, as described on page 22. Verify
the magnet assembly is centered throughout the entire rotating range.
Figure 11. Housing and Mounting for Linear and
Quarter‐Turn Actuators
NOTE: ANY OF THE MOUNTING HOLES
MAY BE USED FOR LINEAR ACTUATORS
W9636‐2
Figure 13. Mounting—Rotary Magnet Assembly
GE42123 Rev A
OPTIONAL
MOUNTING HOLES
MOUNTING HOLES FOR
ROTARY NAMUR, M6
MOUNTING INSERT FACES
MAGNET
ASSEMBLY
Figure 12. For Rotary‐Shaft Actuators (Typical
Mounting Bracket)
ROTARY
MOUNTING
BRACKET
W9637‐2
MOUNTING
INSERT
FACES
19.5 $ 0.8
(0.77 $ 0.03)
BASE OF HOUSING
mm
(INCH)
4310 Wireless Position Monitor
December 2011
17