Emerson TopWorx 4310 Instruction Manual page 24

4310 Wireless Position Monitor
December 2011
Figure 20. Field Communicator Menu Tree—Overview
Field Communicator
1 Offline
2 Online
3 Frequency Device
4 Utility
Online
1 Overview
2 Configure
3 Service Tools
NOTE:
1 THE DEVICE OPTIONS MENU IS AVAILABLE ONLY IF FACTORY OPTIONS ARE INSTALLED
Primary Purpose Variables
Switch States—indicates the position of the monitored equipment (e.g. valve) as a discrete value; OPEN, CLOSED, or
PARTIALLY OPEN.
Switch States Quality—indicates the overall process data quality of the named device variable. Values are 'Good',
'Degraded', 'Bad', and 'Manual/Fixed'.
Update Rate—indicates the interval between scheduled bursts of Message 0.
Join Device to Network
Join Device to Network allows you to enter the Network ID (up to 5‐digits) and the Join Key (4 sets of 8 hexadecimal
digits). The Join Key is used for encrypting the data on the wireless network. The Network ID and the Join Key are the
same for all devices connected to a gateway.
Note
The Network ID is shipped with a default value of 1229 and the Join Key with a default value of all zeros. These must be changed
prior to use.
When the 1420 gateway is configured in an advanced security mode each device is required to have an individual join key.
24
1
Overview
1 Device Status
2 Comm Status
3 Primary Purpose Variable
4 Join Device to Network
5 Device Information
Device Information
1 Identification
2 Revisions
3 Radio
4 Capabilities
5 Local User Interface
Local User Interface
1 Cal Lock-Out
2 LUI language
1‐3
Primary Purpose Variables
1 Switch States
2 Switch States Quality
3 Update Rate
1‐5-2
Revisions
1 Universal
2 Device
3 Firmware
1-5
4 Hardware
5 DD
1‐5-3
Radio Information
1 Manufacturer
2 Device Type
3 Device Revision
4 Software Revision
1-5-5
4 Hardware Revision
5 Transmit Power Le...
1‐5-4
Capabilities
1 Device Profile
2 Device Options
3 Device Flags
4 Total Burst Messages
Instruction Manual
D103391X012
1