Installing Standard And Extended Life Power Module - Emerson TopWorx 4310 Instruction Manual

4310 Wireless Position Monitor
December 2011
D Check with your process or safety engineer for any additional measures that must be taken to protect against process
media.
WARNING
Due to the combustible nature of the lithium content, the power module has special installation, operation, storage, and/or
shipping requirements. Observe all warnings included with the power module before installing, operating, storing, or
shipping the 4310 position monitor. Failure to do so may result in personal injury or property damage from fire or
explosion.
CAUTION
When installing components, proper means of electrostatic discharge protection is required. Failure to use a grounding
strap, or other means of electrostatic discharge protection can result in damage to the electronics.
WARNING
To avoid static discharge do not rub or clean the antenna with solvents.
The 4310 has two available power sources; a battery-sourced power module, or an external power source.
Note
A 4310 powered by a battery-sourced power module cannot be converted to a 4310 powered by an external power source. The
housing and electronics are not the same for a 4310 powered by a battery-sourced power module and a 4310 powered by an
external power source.
Installing Standard and Extended Life Power Modules
There are two battery-sourced power options, standard life and extended life power modules. Refer to figure 2 and 3
when installing.
To install the power modules:
1. Remove the protective tape covering the J1 PWR and J2 GND terminals of the power modules. Refer to figure 2 or 3
for location of terminals.
2. Loosen the two instrument screws and open the cover.
3. Insert the power module.
4. Insert the four electrical connection screws. Do not fully tighten until all four screws have been started.
5. Insert the four smaller mechanical mounting screws to secure the module to the housing.
6
Instruction Manual
D103391X012