<multiplexing mode> =
<tx vpi>
<tx vci>
<rx vpi>
<rx vci>
The <rx vpi> and <rx vci> settings will be equal to those of <tx vpi> and <tx vci> if the rx
settings are not configured.
The set pvc command allows the configuration of a PVC (permanent virtual circuit) for an individual ADSL
port.
7.5.22
Set PVCs Command
Syntax:
192.168.1.1 adsl> set pvcs <multiplexing mode> <tx vpi> <tx vci> [<rx
vpi> <rx vci>]
where
multiplexing mode = either "llc" or "vc"
<tx vpi>
<tx vci>
<rx vpi>
<rx vpi>
The <rx vpi> and <rx vci> settings will be equal to those of <tx vpi> and <tx vci> if the rx
settings are not configured.
The set pvcs command allows you to configure a single PVC for all of the ADSL ports at once.
7.5.23
Show PVC Command
Syntax:
192.168.1.1 adsl> show pvc <port number>
where
<port number>
The show pvc command allows you to display the PVC parameters of an individual ADSL port.
ADSL Commands
Either "llc" or "vc"
The VPI setting of the ADSL port for use with a Tx based network
=
The VCI setting for the ADSL port for use with a Tx based network
=
The VPI setting for the ADSL port for use with Rx based networks
=
The VCI setting for the ADSL port for use with Rx based networks
=
= The VPI setting of the ADSL ports for use with a Tx based network
= The VCI setting for the ADSL ports for use with a Tx based network
= The VPI setting for the ADSL ports for use with Rx based networks
= The VCI setting for the ADSL ports for use with Rx based networks
= A port number, from 1 to 8.
IES-1000 User's Guide
7-13