Regen Port Command - ZyXEL Communications ZyXEL DMA 1000 User Manual

IES-1000 User's Guide
11.2.2

Regen Port Command

Syntax:
192.168.1.1 vlan1q> regen port [<port #> <user priority> <regened
priority>]
where
<port #>
<user priority>
<regened priority> =
This command changes the priority of a tagged frame from a specified ingress port from the original user
priority to the regened priority.
To display the regeneration table, simply use the Regen Port command without parameters, as shown next.
192.168.1.1 vlan1q> regen port
11-2
= A bridge port number. Valid parameter range = [1 – 9].
=
The user priority for a frame received on this port. Valid
parameter range = [0 – 7 or *], where 0 is the lowest priority, 7 is
the highest priority and * means all user priorities.
The regenerated user priority the incoming user priority is
mapped to for <port #>. Valid parameter range = [0 - 7],
where 0 is the lowest priority and 7 is the highest priority.
IEEE 802.1p Priority Commands