Linedata Command - ZyXEL Communications ZyXEL DMA 1000 User Manual

IES-1000 User's Guide
7.5.4 Enable Port Command
Syntax:
192.168.1.1 adsl> enable port <port number>
where
<port number> = A port number, from 1 to 8.
The enable port command forcibly enables the specified ADSL port.
The factory default of all ports is disabled. A port must be enabled before data transmission can
occur. An enabled but disconnected ADSL port generates more heat than an operating port. To
minimize heat generation and to enhance reliability, remember to disable a port when it is not in
7.5.5 Enable Ports Command
Syntax:
192.168.1.1 adsl> enable ports
The enable ports command forcibly enables all ADSL ports.
The factory default of all ports is disabled. A port must be enabled before data transmission can
occur. An enabled but disconnected ADSL port generates more heat than an operating port. To
minimize heat generation and to enhance reliability, remember to disable a port when it is not in
7.5.6

Linedata Command

Syntax:
192.168.1.1 adsl> linedata <port number>
where
<port number> = A port number, from 1 to 8.
The linedata command shows the line bit allocation of an ADSL port.
An example is shown next.
192.168.1.1 adsl> linedata 7
DS carrier load: number of bits per symbol(tone):
tone 0- 31: 0
tone 32- 63: 0
tone 64- 95: 4 44 44 43 43 33 34 44 33 44 44 34 44 43 33 44
7-4
0 0 0 0 0 0
0 0 22 22 33 33 33 33 33 33 44 33 44 44 44
use.
use.
0 0 0 0 0 0 0 0 0
ADSL Commands