Table of Contents
Advertisement
<SES>
<LOSWS>
<UAS>
<downN>
6.6.8
List Port Command
Syntax:
192.168.1.1 gshdsl> list port <port #>
where
<port #>
This command displays information about the line speed, state and the line rate parameter of a G.SHDSL port.
An example is shown next.
192.168.1.1 gshdsl> list port 6
Port=6
Speed(Cmax/Act)=2048/
where
<Cmax>
<Act>
<Cmin>
<State>
6.6.9
List Ports Command
Syntax:
192.168.1.1 gshdsl> list ports
G.SHDSL Commands
errors are found.
=
Severely Errored Second. The total number of one-second intervals when at least fifty
CRC errors are found.
=
Loss of Sync Word Failure Second. Displays the total number of one-second intervals
when one or more SHDSL LOSW errors are found.
=
Unavailable Second. The total number of one-second intervals when the G.SHDSL
line is unavailable.
=
The number of times the G.SHDSL line has been dropped.
=
The port number, from 1 to 8
0Kbps Cmin=192
=
Configured maximum line speed in Kbps. The maximum G.SHDSL line speed you
configured. For details about configuring this parameter see section 6.6.15.
=
The actual G.SHDSL line speed in Kbps.
=
This is the configured minimum line speed in Kbps for this port. The minimum
G.SHDSL line speed you configured.
=
Displays the state of an individual G.SHDSL port and the G.SHDSL line. If this
parameter is disabled, then the G.SHDSL port and line is forced down. If this
parameter is enabled, then the G.SHDSL port and line may be up or down. See next
for more details.
Table 6-2 List Port Command - <State> Parameter
STATE
Enabled
Disabled
State=Disabled/Down
STATUS
Up
Down
Forced down
IES-1000 User's Guide
6-5
Advertisement
Table of Contents
Troubleshooting
