ZyXEL Communications ZyXEL DMA 1000 User Manual page 59

ATU-C (atuc) stands for ADSL Termination Unit-Central and refers to downstream transmission and ATU-R
(atur) stands for ADSL Termination Unit-Remote and refers to upstream transmission.
The profile is a table that contains information on ADSL line configuration. Each entry in this table reflects a
parameter defined by a manager, which can be used to configure the ADSL line.
Note that the default value will be used for any of the above fields that are omitted.
The upstream rate must be less than or equal to the downstream rate.
Even though you can specify arbitrary numbers in the set profile command, the actual rate is always a
multiple of 32 Kbps. If you enter a rate that is not a multiple of 32 Kbps, the actual rate will be the next lower
multiple of 32Kbps. For instance, if you specify 60 Kbps for a port, the actual rate for that port will not exceed 32
Kbps, and if you specify 66 Kbps, the actual rate will not be over 64Kbps.
An example is shown next.
192.168.1.1 adsl> set profile debug 800 8000
This command sets the maximum upstream transmission rate to 800 kbps and the maximum downstream
transmission rate to 8000 kbps. None of the other settings are changed
7.5.13 Delete Profile Command
Syntax:
192.168.1.1 adsl> delete profile <name>
where
<name> = A profile name.
The delete profile command allows you to delete an individual profile by its name.
7.5.14 List Profiles Command
Syntax:
192.168.1.1 adsl> list profiles
The list profiles command displays all of the ADSL ports and that profile is assigned to each one.
An example is shown next.
192.168.1.1 adsl> list profiles
Profile 1 : DEFVAL
Profile 2 : debug
Port 1, Profile : DEFVAL
Port 2, Profile : DEFVAL
ADSL Commands
IES-1000 User's Guide
7-9