Front Panel Connections; Power Port - ZyXEL Communications ZyXEL DMA 1000 User Manual

2.3

Front Panel Connections

2.3.1 LAN Port (Ethernet)
Connect the LAN port of the network module to an Ethernet switch using a straight-through category 5 UTP
(Unshielded Twisted Pair) cable with RJ-45 connectors if you are connecting to a hub or switch. Use a crossover
cable if you are connecting to a single computer.
2.3.2 CONSOLE Port
For initial configuration, you need to use terminal emulator software on a computer and connect it to the network
module through the console port. Connect the RJ-11 connector on one end of the RS-232 console cable to the
console port of the network module. Connect the DB-9 connector on the other end of the console cable to a serial
port (COM1, COM2 or other COM port) of your computer. You can use an extension cable if the enclosed one is
too short. After the initial setup, you can modify the configuration remotely through Telnet.
2.3.3 Ports 1-8 (SAM1008 Ports)
To complete a G.SHDSL connection, connect a telephone line from the subscriber equipment to one of the
SHDSL ports on the SAM1008.
2.3.4 Ports 1-8 (AAM1008 Ports)
The line from the subscriber carries both the ADSL and the voice signals. For each line, the AAM1008 has a
built-in splitter that separates the high frequency ADSL signal from the voice band signal and feeds the ADSL
signal to the AAM1008, while the voice band signal is diverted to the CO port.
To complete an ADSL connection, connect a telephone line from the subscriber equipment to one of the upper
ADSL ports on the AAM1008. Connect a telephone line from one of the lower ADSL ports on the AAM1008 to
the CO switch or PBX (Private Branch Exchange).
2.3.5

POWER Port

Connect the female end of the power cord to the power receptacle on the front panel of your IES-1000. Connect
the other end of the cord to a power outlet. Make sure that no objects obstruct the airflow of the fans. If you are
facing the IES-1000 front panel, the fan vents are located on the left side of the unit.
Make sure you are using a 100 - 240 VAC, 50/60 Hz power source.
Hardware Overview
IES-1000 User's Guide
2-3