Figure 10-2 Example: Svlan List Command Display; Svlan Setentry Command - ZyXEL Communications ZyXEL DMA 1000 User Manual

IES-1000 User's Guide
This command displays the static VLAN registration table. The following figure is an example of what is
displayed when you use this command.
For more information about the Svlan List command display, refer to the Svlan Setentry command (shown next).
10.6.6

SVLAN Setentry Command

Syntax:
192.168.1.1 vlan1q> svlan setentry <vid> <port#> <ad_control>
<tag_control>
where
<vid>
<port#>
<ad_control>
<tag_control> =
This command adds or modifies an entry into the static VLAN table. Display your configuration by using the
Svlan List command. An example of a configuration is shown next.
Modify a Static VLAN Table Example
The following is an example of how to modify a static VLAN table.
10-6
vid port#
-------- -------
1 1
2
3
2 1
2
3
3 1
2
3

Figure 10-2 Example: SVLAN List Command Display

= A VLAN ID. Valid parameter range = [1 – 4094].
= A bridge port number.
Valid parameter range = [1 – 9].
=
Registrar administration control flag.
Valid parameters = [fixed, forbidden, normal].
Select fixed to register a <port #> to the static VLAN table with
<vid>.
Select normal to confirm registration of the <port #> to the static
VLAN table with <vid>.
Select forbidden to block a <port #> from joining the static VLAN table
with <vid>.
The tag control flag. Valid parameters = [tag, untag].
Select tag to add tags to outgoing frames.
Select untag if you do not want to tag outgoing frames.
ad_control tag_control
------------ ------------
fixed Tag
normal UnTag
normal UnTag
normal UnTag
fixed UnTag
normal UnTag
normal UnTag
normal UnTag
fixed UnTag
IEEE 802.1QTagged VLAN Commands