Enable Command - ZyXEL Communications ZyXEL DMA 1000 User Manual

12.2.11

Enable Command

Your telnet session disconnects when you change the Ethernet port's IP address. Initiate a
telnet session to the new IP address in order to reconnect.
Syntax:
192.168.1.1 ip> enable [<i/f> [mtu <size>] [<IPaddr>]]
where
<i/f>
[mtu <size>] =
<IPaddr>
This command sets the Ethernet port's IP address and the largest packet size that this interface sends.
IP Commands
=
The name of an interface ("ether" for this device).
Maximum Transmit Unit. The maximum packet size that this interface is to
send.
=
The IP address of the device's interface.
IES-1000 User's Guide
12-5