Cab Component Installation; Install The Smartrax Node; Mount The Smartrax Node - Raven SmarTrax Case IH Steiger Series Installation Manual

CHAPTER
4

Install the SmarTrax Node

Mount the SmarTrax Node

Note:
The SmarTrax node (P/N 063-0173-228) is sold separately. Contact your local Raven dealer for
ordering information.
SmarTrax Node Installed
FIGURE 1.
Mount the SmarTrax node to the node mounting bracket (P/N 107-0172-084) using three 3/8"-16 nylon
1.
insert lock nuts (P/N 312-4000-061).
Install the two large, rectangular connectors of the node harness (P/N 115-4001-126) into the correct ports
2.
of the node.
Tighten the bolts on the harness connectors to secure the connections.
3.
Place the node mounting bracket under the instructional seat, aligning the holes in the mounting bracket
4.
with the existing holes in the cab floor.
Note:
The node connectors should be pointing toward the operator's seat.
Secure the node mounting bracket to the floor using four M6 x 1.00 x 20 mm bolts (P/N 311-0070-010), four
5.
1/4" flat washers (P/N 313-2300-009), and four M6 lock nuts (P/N 312-4000-207).
Manual No. 016-5032-004
C ab Component
C h a p t e r 4
Installation
17