Table of Contents
Advertisement
Chapter 5
Install the Yaw Sensor
When choosing the location for the yaw sensor, consider the following points:
•
The yaw sensor is not weatherproof. Mount the sensor inside the cab.
•
Mount the yaw sensor in a location away from foot traffic.
•
Mount the yaw sensor to a flat, level surface. The floor of the cab is generally ideal.
•
Mount the yaw sensor so that the Raven logo faces up.
•
The SmarTrax yaw sensor does not need to be oriented toward the direction of vehicle travel.
Note:
If you are going to use the double-sided tape to mount the SmarTrax yaw sensor, be sure to
thoroughly clean and dry the mounting location first.
To Install the Yaw Sensor
Select the preferred location for the SmarTrax yaw sensor (P/N 063-0172-684). See the recommendations
1.
for choosing a mounting location above.
Mount the yaw sensor using one of the following methods:
2.
•
Remove the protective covering from the double-sided tape and affix the yaw sensor to the floor.
•
Using the yaw sensor as a template, mark and pre-drill holes in the floor. Using bolts or screws
(not supplied), secure the yaw sensor in position.
Locate the connector labeled 'YAW SENSOR' on the SmarTrax console cable harness (P/N 115-0171-775).
3.
Insert this connector to the yaw sensor cable connection.
4.
Yaw sensor Model
FIGURE 3.
20
CaseIH MX 210, 230, 255, and 285 SmarTrax Installation Manual
Advertisement
Table of Contents
