Table of Contents
Advertisement
7. Entering Initial Installation Information
You can use the following procedure to enter the initial installation information and to monitor the operational
information of this system appropriately on server.
7.1 Preparations for installer
• A laptop or a smart phone is required.
7.2 Overview of initial information input stages
• Connect PC to ESS → Input local settings → Connect to web page → Input webpage settings
7.3 PC Connection and Local Settings
7.3.1 Overview of PC connection stages
7.3.1.1 Direct connection
This describes how to establish direct connection from installer's laptop ("laptop") to Q.HOME
• Turn off system → Insert short bar on Out connector board ("board"), now board has static IP address → Connect
LAN cable from laptop to board → Turn on system → Connect laptop to board via internet browser → Input
settings → Turn off system → Remove short bar from pin → Turn on system.
7.3.1.2 Network connection
This describes how to establish connection from laptop to ESS using existing network.
• Check IP address from LDC screen on ESS, ESS has DHCP IP address in default → Connect LAN cable from
laptop to network switch or hub → Connect laptop to board via internet browser → Input settings
7.3.2 TCP/IP connection
7.3.2.1 LAN Cable Specification
• Ethernet cable: UTP CAT.5E
• RJ45 Termination: Direct T568B-T568B
7.3.2.2 IP settings
In order to establish connection between laptop and ESS, change TCP/IP settings on the laptop as shown
below :
• Laptop → [Control panel → Network and Sharing Center → Change adapter settings → Local Area Connector
→ Properties → Internet Protocol Version 4 (TCP/Ipv4)]
IP address: 17.91.23.1
Subnet mask: 255.255.224.0
Default gateway: 17.91.1.2
+
Entering Initial Installation Information
ESS HYB-G2 ("ESS").
I
48
Advertisement
Table of Contents
