Related Manuals for Q CELLS Q.MAXX-G2
Summary of Contents for Q CELLS Q.MAXX-G2
- Page 1 INSTALLATION AND OPERATION MANUAL Q.MAXX-G2 solar module series Valid for Africa, Europe, LatinAmerica, South America...
-
Page 2: Table Of Contents
DOCUMENT REVISION 04 This manual is valid for Australia and New Zealand as of November 1st 2020 for Q.MAXX-G2 solar modules, and replaces all earlier versions. This manual is subject to change. The data sheets and customer information valid at the point in time when the relevant module was manufactured apply to the installation, mounting, and maintenance procedures for the respective solar modules, as far as no updated document is provided. -
Page 3: Introduction
The installer of the system is responsible for compliance with all Ä Width 1030 mm necessary safety regulations during set-up and installation. Q CELLS assumes no liability on the basis of these instructions. Frame height 32 mm Q CELLS is only liable in the context of contractual agreements Area 1.79 m²... -
Page 4: Requirements
Fig. 2: Forces acting on the module are relayed to the mounting Installation options for crystalline Q CELLS modules. All dimensions are given in mm. Also observe the maximum Please note the following guidelines that apply to the installation substructure. -
Page 5: Electrical Layout
The loads in the table are related to the mechanical stability of the solar modules. The mechanical stability of the mounting system including clamps has to be evaluated by the system supplier. The listed test load values for Q CELLS were determined with the following clamp parameters: clamp width = 40 mm and clamp depth = 10 mm. -
Page 6: Installation
/ vapors. rooms. The packaging is not weatherproof. Ä Do not install modules in close proximity to air conditioning systems. INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.MAXX-G2 – Q CELLS INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.MAXX-G2 – Q CELLS... -
Page 7: Preparation Of Installation
Ensure that modules and tools are not subject (e.g. do not drill any additional holes). to moisture or rain at any time during instal- lation. INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.MAXX-G2 – Q CELLS INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.MAXX-G2 – Q CELLS... -
Page 8: Electrical Connection
Only use dry, insulated tools for electrical Ä Insulate any exposed cable ends. work. Only connect cables with plugs. Ä INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.MAXX-G2 – Q CELLS INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.MAXX-G2 – Q CELLS... -
Page 9: Connection Of Modules
AS / NZS 3000 and all other the side with negative connection cable. relevant standards. Inverter click 180° 180° INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.MAXX-G2 – Q CELLS INSTALLATION AND OPERATION MANUAL SOLAR MODULES Q.MAXX-G2 – Q CELLS... -
Page 10: Grounding
FAULTS AND DEFECTS MAINTENANCE AND CLEANING Protective Grounding DANGER! Q CELLS solar modules are known for a long operating life and Note! Module damage may occur! Ä The modules must be grounded in accordance with the local Risk of fatal injury due to electric shock! minimal maintenance effort and expense. - Page 11 AUSTRALIA PTY LTD Suite 1, Level 1, 15 Blue Street North Sydney, NSW 2060 Australia +61 (0)2 9016 – 3033 +61 (0)2 9016 – 3032 EMAIL q-cells-australia@q-cells.com www.q-cells.com/au Subject to change without notice. © Q CELLS Installation manual solar modules Q.MAXX-G2_2020-11_Rev04_AU...
Need help?
Do you have a question about the Q.MAXX-G2 and is the answer not in the manual?
Questions and answers