Battery Connection Method - Q CELLS Q.VOLT-G2 HYB-4.6kW.1.1 Installation Manual

5.6.4 Battery Connection Method

To connect the Battery, you need 3 connections :
Ground, (+) and (-). In any case, connection of the INVERTER to ground is mandatory.
To connect the Battery, insert the cable into the INVERTER through the Battery cable gland.
Strip 9 mm of cable from the cable to connect to Load. Connect the Battery cable to the Filter Board CN401.
After lifting the handle of connector, insert the cable and lower the handle of the connector to secure the
Battery cable. Be sure to use the correct size cable and be cables are not loose.
As shown in [Figure 5-17], use the ring terminal to connect the ground wire to the correct location.
6. Change the switch on.
Move
the switch.
39 I
Electrical Connections
[ Figure 5-16 : Power Cable Connection to the Load Connector ]
Battery
[ Figure 5-17 : Ground Location of Grid and Load ]
[ Figure 5-18 : Battery Pack Switch ]
Load Grid