Table of Contents
Advertisement
4.1.1 Dimensions
Once the Q.HOME
ESS HYB-G2 has been assembled, its dimension is 467.6 x 721.6 x 212.5 mm.
+
The [Figure 4-1] show the outer dimensions of the device after assembly, respectively.
467.6 mm
4.1.2 Ambient Conditions and Temperatures
Check a proper installation location to install and remove the device easily at any time.
This device must be located within reach distance. The ambient temperature of the installation location is
-20 °C - 50 °C for the inverter, 0 °C - 40 °C (4 kWh) or -10 °C - 40 °C (6.3 kWh) for the battery.
4.1.3 Environmental checks
When choosing installation location, observe the following conditions :
• The installation location must be easily accessible.
• Prevent access to the installation location by children.
• Installation of the unit in a location exposed to solar rays must be avoided as it may cause :
- power limitation phenomena in the INVERTER (with a resulting decreased energy production by the system)
- premature wear of the electrical/electromechanical components
- premature wear of the mechanical components (gaskets) and of the user interface (display)
- reduction in performance, lifetime and possible damage of the Battery pack
• Always ensure that the flow of air around the INVERTER is not blocked so as to prevent overheating.
• Do not install in locations where flammable substances or gases may be present.
• You can install in locations with a constant presence of water and/or high humidity level,
but not recommended.
• Do not install in rooms where people live or where the prolonged presence of people or animals is
expected, because of the noise that the INVERTER produces during operation.
212.5 mm
[ Figure 4-1 : Dimension of Q.HOME
467.6 mm
212.5 mm
ESS HYB-G2 ]
+
I
20
Installation
Advertisement
Table of Contents
