Table of Contents
Advertisement
3. Package Removal and Inspection
CAUTION
Included in this box are a Battery and printed circuit board. Therefore, special care
must be taken in handling. Make sure to have at least two persons deliver and remove
the package.
3.1 Package Removal
3.1.1 Removing the INVERTER Enclosure Package
As shown in the [Figure 3-1], remove the package components from the enclosure in the following order.
1. Place the system on the installation location.
2. Turn the box upside down.
3. Open the box.
4. Remove the cover on the back of the product.
5. Remove the protective cover on the side of the product.
6. Prepare the lower bracket for the INVERTER. (3 Down Bracket Screws, 1 Down Bracket)
7. Assemble the lower bracket to the INVERTER.
8. Lift the INVERTER.
P C S
(1)
(5)
[ Figure 3-1 : Process for the INVERTER Enclosure Package Removal ]
13
I
Package Removal and Inspection
(2)
(6)
(3)
(4)
(7)
(8)
Advertisement
Table of Contents
