Floor Mount - Mounting Instructions - Q CELLS Q.VOLT-G2 HYB-4.6kW.1.1 Installation Manual

4.3 Floor Mount - Mounting Instructions

NOTICE
• The Floor Mount must use the frame provided by the manufacturer, All four directions
should be fastened with bolts to the bottom.
Mount Plate
(1ea)
Battery
• Step 2 : L-Bracket (Screw M8x16, 4point)
D-Bracket (Screw M6x8, 4point)
• Step 4 : After tightening the Upper Wall Bracket,
tighten the nut (M8, 2point).
M8x45, Washer
(2 point)
* Use the Wall Mount Screw
to disassemble it.
25 I
Installation
Stand Column D-Bracket
(2ea) (2ea)
[ Figure 4-9 : Floor Mount Part List ]
40 mm
STEP 2
STEP 4
L-Bracket Screw M8x16
(4ea) (8ea)
STEP 1
Inverter
430 mm
• Step 3 : After assembling Stand Column on
Mount plate, tighten Screw(M8x16, 4point).
• Step 5 : Secure the Mount plate to the floor.
Screw M6x8 Nut M8
(4ea) (2ea)
• Step 1 : Mark guideline on floor.
- Bolt : M12-16 x L30 mm (Min)
STEP 3
STEP 5
M12-16 Nut,
Washer (4Point)