System General Events (Protection) - Q CELLS Q.VOLT-G2 HYB-4.6kW.1.1 Installation Manual

9.1.3 System General Events (Protection)

WEB Display HMI Display
P01P Unknown
P03P DSP-EMG
TRIP P
P11P ADC P
P12P DSPM
UPDATE P
P13P DSPS
UPDATE P
P14P PMS
UPDATE P
P15P DSP VER P
P16P PMS VER P
P21P DSPM FRAM
P
P22P DSPS FRAM P
P23P DSP COM P
97 I
Problem Confirmation
Type : PROTECTION
Description
Unregistered Failure
DSP-Emergency Trip
Protection
ADC Measure Error
Protection
DSP Master Remote
Update Fail Protection
DSP Slave Remote
Update Fail Protection
PMS Remote Update
Fail Protection
DSP Firmware Version
Error Protection
PMS Firmware Version
Error Protection
DSP Master FRAM
Communication Error
Protection
DSP Slave FRAM
Communication Error
Protection
DSPM-DSPS
Communication Error
Protection
[ Table 9-3 : System General Events Protection List ]
Measures
It is an unregistered fault. Turn off and restart
the system. Please contact the Q CELLS
Service –Hotline, if an error occurs
continuously.
Please check emergency switch.
Please turn off and restart the system.
If an error occurs repeatedly, it is necessary
to replace the Control Board.
Please update DSP Master software again.
Please update DSP Slave software again.
Please update PMS software again.
DSP and PMS versions are different.
Please re-install the DSP software.
Please update DSP Slave software again.
Please turn off and restart the system. If an
error occurs repeatedly, it is necessary to
replace the Control Board.
Please turn off and restart the system.
If an error occurs repeatedly, it is necessary
to replace the Control Board.
It is an unregistered fault. Turn off and restart
the system. Please contact the Q CELLS
Service –Hotline, if an error occurs
continuously.