Table of Contents
Advertisement
Internet Service Settings
This page allows you to configure the settings for CentreWare Internet Services.
Auto Refresh
Allow you to select whether to refresh the contents displayed automatically. You may set [On] or [Off]
for this feature. The default is [On].
Auto Refresh Interval
Enter a time when the contents displayed will be refreshed automatically. The interval can be
between 55 and 600 seconds.
Administrator Name / Password Change
Select this check box if user wants to change administrator name and password settings.
Administrator Name
Enter the administrator name for CentreWare Internet Services with not more than 8 characters. You
can use both alphanumeric characters and symbols.
Administrator Password
Enter the administrator password for CentreWare Internet Services. Only support 4 digit numbers.
Administrator Password that has been set will not be displayed on the screen.
Re-enter Password
Re-enter the same password to verify the administrator password.
Administrator Password that has been set will not be displayed on the screen.
Only Administrators can create of change addresses
Specifies whether to appoint the administrator as the only user entitled to change device settings on
address book settings. The available values are [On] and [Off]. The default is [Off].
When Administrator Mode is set to [On], the Administrator ID and Administrator Password will be
requested by the system when changes are made to the address book settings.
Port Status
This page displays the port settings and allows you to enable or disable different ports used in the device.
Ports to be used will be set to Enabled.
The port displayed will differ depending on the printer model and the options installed.
The setting for this item will be valid only when the device is restarted. Click the [Apply New Settings and
Reboot Device] button to restart the device.
SNMP Client
Selects [Enable] or [Disable]. You can also configure the transport protocol to be used. UDP and
IPX can be selected simultaneously as the transport protocol.
LPD
Selects [Enable] or [Disable].
Port9100
Selects [Enable] or [Disable].
Port Settings
Ethernet Settings
This page allows you to configure the settings for Ethernet.
Ethernet Settings
Selects Ethernet transmission rate from the following.
Auto
All manuals and user guides at all-guides.com
- 175 -
Advertisement
Table of Contents
