8. To enable HD control for video signals, Ethernet, or IR, select HDBaseT Keypad Enabled
and select Enter.
Setting the remote access level
Determine if and how the projector can be accessed remotely for the RS232 port or the Ethernet.
1. From the home page, select MENU > Admin > Service.
2. Enter the service password.
3. To determine the remote access for the Ethernet port, select Remote Access Level
(Ethernet).
4. Select the appropriate remote access level:
•
No Access
•
Login Required
•
Free Access
5. Select Enter.
6. To determine the remote access for the RS232 IN port, select Remote Access Level
(RS232 IN).
7. Select the appropriate remote access level:
•
No Access
•
Login Required
•
Free Access
8. Select Enter.
Enabling direct pass-through of HDMI, 3G, and
DisplayPort input signals
Allow the signals from HDMI, 3G, and DisplayPort inputs to pass through another projector.
1. Select MENU > Configuration > Input Settings > Enable Video Loop Out.
2. To enable passing HDMI, 3G, and DisplayPort input signals through to another projector,
select Enter.
Adjusting lamp power
Change the power of the lamp.
1. Select MENU > Configuration > Lamp > Lamp Power.
2. Press Enter.
3. To adjust the lamp power, use the slider.
4. To confirm your selection, select Enter.
Boxer 30 (Bb.2) User Manual
020-102016-02 Rev. 1 (02-2016)
Copyright
2016 Christie Digital Systems USA Inc. All rights reserved.
©
Configuring system settings
28