Enabling Camera Friendly Color Mode - Christie Crimson Series User Manual

Hide thumbs Also See for Crimson Series:

Table of Contents

3. To confirm your selection, select Enter.

4. Repeat steps 2 and 3 for each laser color.

Enabling Camera Friendly Color mode

Some digital camera equipment presents the images generated by Christie laser products with a

noticeable red shift. These images do not represent how human vision perceives the projected image

and are an effect of the camera charge couple device (CCD) but do not reflect the images generated

by Christie laser products.

To mitigate this, enable the Camera Friendly Color mode so the target white-point is set to a cooler

color temperature. This significantly reduces the observed effect and Christie recommends using this

mode for sites wanting to take photographs of the projected images. The target Camera Friendly

White x and White y settings default to an appropriate value but can be modified in MENU > Admin >

Service > Light & Output Settings.

1. From the display panel, select MENU > Admin > Service.

2. Enter the service password.

3. Select Light & Output Settings.

4. To enable the Camera Friendly Color mode, select Camera Friendly Color Mode > On.

If you only want to enable or disable Camera Friendly Color mode without changing the White

x and y values, navigate to Configuration > Light & Output Settings.

5. To set the white color targets, enter the required Camera Friendly White x and Camera

Friendly White y values.

The default value is determined to improve the red-hue issue.

Crimson Series User Guide

020-102649-07 Rev. 1 (05-2023)

If printed, please recycle this document after use.

Configuring system settings

Table of Contents