Christie Crimson Series User Manual page 45

Channel Name
1 Slider Lock
2 Power
3 Shutter
4 Lens Shift Enable
5 Zoom (Coarse)
6 Zoom (Fine)
7 Focus (Coarse)
8 Focus (Fine)
9 Lens Horizontal
Position (Coarse)
10 Lens Horizontal
Position (Fine)
11 Lens Vertical Position
(Coarse)
Crimson Series User Guide
020-102649-07 Rev. 1 (05-2023)
Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Description
0 to 171 = Locked
172 to 255 = Unlocked
0 to 85 = Powers off the
projector (goes into
Standby mode)
86 to 171 = Cancel timer
172 to 255 = Powers on
the projector (switches
light source on, warm up
mode)
0 to 85 = Closes the
shutter (black screen)
172 to 255 = Opens the
shutter (live video)
0 to 171 = Disables lens
shift
172 to 255 = Enables lens
shift
0 = Smallest image
possible (0%)
255 = Largest image
possible (100%)
0 = 0%
255 = 100%
0 = Full left position (0%)
255 = Full right position
(100%)
0 = Full lower position
(0%)
Configuring communications
Suggested Notes
starting
position
0 —
128 Must be valid for five seconds
before it is applied.
255 Christie recommends setting
this channel to 255 prior to
powering up the projector so
it is consistent with the
shutter state after the
projector is fully on.
— Locks all lens motors.
128
• Locked by the Lens Shift
Enable channel.
• Scaled as a percentage of
the total control range.
• A 250 ms delay exists
before sending this
channel to the projector.
128
• Locked by the Lens Shift
Enable channel.
• Scaled as a percentage of
the total control range.
• A 250 ms delay exists
before sending this
channel to the projector.
128
• Locked by the Lens Shift
Enable channel.
• A 250 ms delay exists
before sending this
channel to the projector.
128
• Locked by the Lens Shift
Enable channel.
45