Enabling Direct Pass-Through Of Hdmi, 3G, And Displayport Input Signals; Informing The Source Of Signal Preferences; Configuring The Laser Power Settings - Christie Mirage SST User Manual

Enabling direct pass-through of HDMI, 3G, and
DisplayPort input signals
Allow the signals from HDMI, 3G, and DisplayPort inputs to pass through another projector.
1. Select MENU > Configuration > Input Settings > Enable Video Loop Out.
2. To enable passing HDMI, 3G, and DisplayPort input signals through to another projector, select
Enter.

Informing the source of signal preferences

Configure Mirage SST to automatically inform the video source of the preferred signal formats.
1. If you need a specific frame rate, from the display panel, select MENU > Configuration >
Input Settings > EDID Timing.
2. Select the required EDID timing and select Enter.
60 Hz is the default EDID timing.

Configuring the laser power settings

Projector profiles contain the power settings for the RGB laser light source.
1. To display the white test pattern, MENU > Test Pattern
2. Scroll through the list of test patterns and select White.
3. To confirm your selection, select Enter.
4. Select MENU > Image Settings > Color & Gamma > Color Correction Mode.
5. Select Max Drives and to confirm your selection, select Enter.
6. Select MENU > Configuration > Light & Output Settings.
7. To set the approximate red power level, select Red Laser Setpoint and use the slider to
increase and decrease the value required for your projection environment.
To turn off the red lasers but leave them in a ready state, select Red Laser Enable to clear
the checkbox.
8. To set the green (Green Laser Setpoint) and blue (Blue Laser Setpoint) power levels,
repeat step 7.
To turn off either the green or blue lasers but leave them in a ready state, select Green Laser
Enable or Blue Laser Enable to clear the checkbox.
9. If color is not at the target level, refine the red, green, and blue power settings to achieve the
target by repeating steps 7 and 8.
10. To control the brightness once the colors are set, select Maser Laser Power and use the
slider to increase or decrease the value.
To turn off all lasers but leave them in a ready state, select Maser Laser Enable to clear the
checkbox.
11. To save the new laser settings, save to a projector profile.
Mirage SST User Guide
020-102993-01 Rev. 1 (06-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Configuring system settings
37