Maintenance; Cleaning; Service Levels - Safran LRF 6042 Manual

LRF 6042 Integrator Manual

9 Maintenance

9.1 Cleaning

Optics:
 Particles of dirt should be blown off or removed using a soft brush.
 Fingerprints may be cleaned first by wiping with a damp cloth, followed by soft, clean optical
tissue or chamois leather.
NOTICE
 Do not use impregnated lens cleaning cloth.
 Do not use any solvent, alcohol or cleansers. Use water.
Cleaning the rest
 Protect electronics, plugs and cables from damp and dirt as much as possible
 Allow the device to dry fully before packing.
 Blow out dust carefully with clean air and leave to dry.

9.2 Service Levels

During the design phase of the LRF modules, the ILS principles were considered and applied to get an
optimized system as regards technical performance and Life Cycle Costs (LCC).
The LRF modules design ensures minimum maintenance activities, resulting in minimum LCC, with current
and modern technologies.
The following service levels are based on SAFRAN VECTRONIX AG ILS standards.
Level 1: User / Customer Maintenance as indicated in cleaning section.
Level 2: Field Maintenance  not applicable
Level 3: Depot Maintenance  not applicable
Level 4: Factory Repair
In case of a defect, the module has to be returned to the SAFRAN VECTRONIX AG Customer Service
Center, where diagnosis and repair or replacement, depending on cost to repair will be done. Please visit our
Service Website http://www.safran-vectronix.com/service/
Our customer and information service will be glad to offer assistance or if you require any other information,
please contact us as the address below.
Safran Vectronix AG
Max-Schmidheiny-Strasse 202
CH-9435 Heerbrugg
(Switzerland)
Phone: +41 71 726 72 00
Fax: +41 71 726 72 01
vectronix@safrangroup.com
Internet: www.safran-vectronix.ch
INTEGRATOR MANUAL LRF 6042 917657- A
Confidential & Proprietary  SAFRAN VECTRONIX AG – All rights reserved
to see how to return a module.
Public: 02.2022
Page: 54/64