Table of Contents
Advertisement
LRF 3013 Integrator Manual
7 Maintenance
7.1 Cleaning
Optics:
Particles of dirt should be blown off or removed using a soft brush.
Finger prints may be cleaned first by wiping with a damp cloth, followed by soft, clean optical
tissue or chamois leather.
Do not use impregnated lens cleaning cloth.
Do not use any solvent, alcohol or cleansers. Use water.
Remove dirt by blowing or using a brush.
Clean fingerprints with a damp cloth and optical tissue
Cleaning the rest
Protect electronics, plugs and cables from damp and dirt as much as possible!
Allow the device to dry fully before packing.
Blow out dust carefully with clean air, and leave to dry.
7.2 Service
7.2.1
Service Levels
During the design phase of the LRF modules, the ILS principles were considered and applied to get an
optimized system concerning technical performance and Life Cycle Costs (LCC).
The LRF modules design ensures minimum maintenance activities, resulting in minimum LCC, through
use of currently available and modern technologies.
Following service levels are based on Vectronix ILS standards.
Level 1: User / Customer Maintenance -> See 7.1 Cleaning.
Level 2: Field Maintenance -> not applicable
Level 3: Depot Maintenance -> not applicable
Level 4: Factory Repair
In case of a defect, the module has to be returned to the Vectronix Customer Service Center. There,
diagnosis and repair or replacement, depending on economic reasons will be done.
Document number: TML 913655 ver A
Confidential & Proprietary Safran Vectronix AG – All rights reserved
Public: 13.03.2017
page: 31/36
Advertisement
Table of Contents
