Table of Contents
Advertisement
LRF 6042 Integrator Manual
3 Getting Started
This chapter will help you with the first steps with a LRF module.
3.1 Unpacking
Open the packaging and carefully pull the module out of the foam packaging without touching the lens
surfaces. Check cleanliness of the module and carefully remove any particles.
NOTICE
Be careful with ESD:
The LRF module is sensitive to electrostatic discharge. Do not touch any electronics or
components unless protective measures are applied.
The packaging consists of a cardboard box and PE-LD-E-X packaging foam. Dispose it according
to your local regulations.
NOTICE
Be careful with EMC:
To avoid / reduce emitting noise, noise susceptibility and coupling between sources and receptors,
the LRF module shall be mounted inside an electrical shielded housing. EMC disturbance can
cause incorrect or no measurement.
NOTICE
Be careful with the optics:
Scratches and fingerprints on the optics will reduce range performance.
The front lens is not sealed and therefore the LRF is not gas or watertight.
Remove the yellow stickers on bench holes only before flushing the air out of the system, so that
nitrogen can fill the optical system of the LRF module (see chapter 4.6).
INTEGRATOR MANUAL LRF 6042 917657- A
Confidential & Proprietary SAFRAN VECTRONIX AG – All rights reserved
Public: 02.2022
Page: 15/64
Advertisement
Table of Contents
