Mounting
Mounting Options
Step by Step
1. Mark the holes
①
a suitable 8 mm drill bit and drill holes with at least 60 mm/1.2" depth.
2. Fully push the dowels
3. If you If you use the 0° set, close the cable openings
plugs. Fix each of them in place from the inside using a small hexagonal nut.
4. Fit the cable gland
outside. Fix it in place from the inside using a small hexagonal nut.
42 / 72
for drilling using the drilling template (see
W.8, p. 20
into the holes you drilled.
③
to the cable opening of the On-Wall Set such that the black rubber seal is on the
Drilling Template, p.
②
that are not needed with the enclosed closing
11). When drilling, use