Table 100-87: Accident Prevention Legislation Test; Table 100-88: Bearing Maintenance; Table 100-89: Bearing Maintenance Message Display Programming - Miele PW 6 7 Series Technical Information

Technical Information
Service mode (service level)
3 Service settings
1 Basic settings
9

Table 100-87: Accident Prevention Legislation Test

After selecting a value with the multifunction selector switch, confirm it with
the OK button. The control automatically goes back one level.
Save settings by pressing and releasing the Save button.
Pressing the Back button quits without saving and goes back one menu
level.
The drum bearings must be lubricated every 1000 operating hours. A
reminder for the operator can be set, if desired, that will read, "Bearing
maintenance! Call the service department." After lubrication has been carried
out, the technician can delete the message via service mode.
Service mode (service level)
3 Service settings
1 Basic settings
10

Table 100-88: Bearing Maintenance

After selecting a value with the multifunction selector switch, confirm it with
the OK button. The control automatically goes back one level.
Pressing the Back button quits without saving and goes back one menu level.
Service mode (service level)
3 Service settings
1 Basic settings
10

Table 100-89: Bearing Maintenance Message Display Programming

Accident prevention legislation display
Accident prevention
1
legislation display data
Bearing maintenance
1 Bearing maintenance data
Bearing maintenance
1 Bearing maintenance
114
Display
"Accident prevention
legislation display: No",
Save, Back
Display Explanation
Field with value "Yes" or "No". The
technician can check this setting
later using service mode or a laptop
"Bearing
with MDU. If "Yes" is programmed,
maintenance:
the message "Bearing maintenance!
Yes, Save, Back"
Call the service department" will be
displayed after 1000 operating
hours. Factory setting: No.
PW 6xx7
Explanation
Field with value "Yes" or
"No". The technician can
check this information
later using service mode
or a laptop with MDU. If
"Yes" is programmed, the
message "accident
prevention legislation-test.
Call the service dept." will
appear in the display after
a year has passed since
the last Reset the accident
prevention legislation
display. Factory setting:
No.