Table 100-23: Setting Options - Program Step - Intake Paths 1 And 2; Table 100-24: Case Divisions - Suds Container Temperatures; Table 100-25: Valve Activation Summary - Automatic Water Intake Setting, Part 1 - Miele PW 6 7 Series Technical Information

PW 6xx7
No. Program step
10 or Intake path 1 or
19 2

Table 100-23: Setting Options - Program Step - Intake Paths 1 and 2

With the "Automatic" setting, the control selects which valves to operate and
attempts to achieve the target wash cycle temperature during the first water
intake. A prerequisite for this is that a hot-water supply with suitable
temperature must be available. Which valve is activated by the control
depends on the program area and program block of the wash program, as
well as any modifications such as the hard-water kit (valve KH) and water
recycling (valve K6) that might apply.
Three basic factors affect the control, depending on temperature range:
Actual temperature > Target temperature
Actual temperature = Target temperature
Actual temperature < Target temperature

Table 100-24: Case Divisions - Suds Container Temperatures

Valve activation summary - Automatic water intake setting, part 1:
Program area
1 (pre-wash) only 1 block
1 (pre-wash) with 2 to 10 blocks
2 (main wash) only 1 block without pre-wash
2 (main wash) with 1 to 10 blocks with pre-wash
3 (rinse)
3 (rinse) with 2 blocks
3 (rinse) with 3 blocks
3 (rinse) with 4 to 10 blocks

Table 100-25: Valve Activation Summary - Automatic Water Intake Setting, Part 1

Valve activation summary - Automatic water intake setting, part 2:
Basic setting Setting
options
Automatic Automatic
User-defined
Program block
1
1
2 to 10
1
1 to 10
1
1
2
1
2
3
1
2
3 to 9
10 (last)
79
Technical Information
Notes
Depending on the program block,
installed optional extras and the current
water temperature in the suds
container, the control selects the valves
to be opened. In order to save energy, if
possible, the control will attempt to
achieve the target block wash cycle
temperature during the first water intake
by operating the cold and hot water
valves alternately.
The programmer selects No for water
inlet valves 1 to 4 or, for each valve, 1
of 11 possible options from the list "K1",
"K2", "K3", "K4", "K6", "KD", "KH", "W1",
"W2", "WD".
Valve 1
Valve 2
Valve 3
Valve 4
Actual temperature > Target temperature
KD, K1
KD, K1
KD, K1
KD, K2
KD, K2
KH, K3
KH, K4
KH, K3
KH
KH, K4
KH, K3
KH
KH, K4
KH
KH, K3