Program Step Spin - Miele PW 6 7 Series Technical Information

PW 6xx7
maximum level in the current block and 0 mm wc. With the Miele Profitronic
M programming and archiving software, however, Drain level 1 can be set
between 350 and 0 mm wc.
Usually, spinning during the entire drain interval is desired. Spinning prevents
residual water from sticking to the laundry, and allows the water to drain out
from between the items of clothing.
Example 1:
The machine comes out of Wash time 3 with a water level of 150 mm wc in
the suds container. Wash time 4 has been set to one minute. The
programmer now sets the level for Drain level 1 (Step 29) to 75 mm. This
means that the drum remains stationary while the water is drained from 150
mm to 75 mm. As soon as the water level drops below 75 mm, the drum will
start spinning.
Example 2:
The machine comes out of Wash time 3 with a water level of 150 mm wc in
the suds container. Wash time 4 has been set to one minute. The
programmer now sets the level for Drain level 1 (Step 29) to 300 mm, which
means that spin occurs while the water is drained from 300 mm to 0 mm.
Because there is only 150 mm wc in the suds container, the drum will spin
during the entire drain interval.
Save and quit:
1. After entering the last parameter, press and release the right multifunction
button ("back" symbol).
2. Press and release the right multifunction button ("back" symbol).
3. Press and release the button under the "save" symbol (disk symbol).
4. Press and release the right multifunction button ("back" symbol) until the
desired menu level is reached. Or switch off the machine.
Quit without saving:
Switch off the machine. Or press and release the right multifunction button
("back" symbol) until the program selection menu level is reached.
4.4

Program Step Spin

Initial requirements:
A wash program must not be in operation.
The machine must not be in the service mode.
Accessing:
1. Switch on the machine.
2. Wait until the Welcome start screen is displayed.
3. Press the language selection button (under the flag symbol) to access the
main menu.
4. Select Operating level and confirm with the OK button.
5. Enter the password and confirm with the OK button.
6. Select Programming and confirm with the OK button.
7. Select the Set up again or Change submenu and confirm with the OK
button.
8. Carry out program header programming.
9. Select a program area and confirm with the OK button.
85
Technical Information