Table 100-69: Active Time Drain Outlet Open; Table 100-70: Water Inlet - Miele PW 6 7 Series Technical Information

Technical Information
Service mode (service level)
3 Service settings
1 Basic settings
1

Table 100-69: Active Time Drain Outlet Open

Make a selection with the multifunction selector switch and confirm with the
OK button.
The Back button can be pressed to go back one menu level.
Save service messages by pressing and releasing the Save button.
The Back button quits without saving and goes back one menu level.
Water inlet has the following subdivisions:
Service mode (service level)
3 Service settings
1 Basic settings
2

Table 100-70: Water Inlet

Make a selection with the multifunction selector switch and confirm with the
OK button.
The Back button can be pressed to go back one menu level.
The technician can program settings for other connection requirements and
valves.
Programming water valve flow rates, e.g., if special valves are being used:
Water drain
1 Drain
2 Active time drain outlet open
Permanent
From 5 s to 60 s in 1
s steps
Water inlet
1 Flow rate
2 Valve block
3 Water valve cold, hard
4 Flow meter
104
Display Explanation
Signal "AVauf" is always
generated. If the setting
Permanent cannot be
modified, then the
machine control has
Permanent been programmed to
Drain pump via Service
levelService settings
Basic settings
Water drainDrain;
see Table 100-68.
To match the length of
the "AVauf" activation
signal. Can only be
selected if Valve is
From 5 s to 60 s programmed via Service
levelService settings
 Basic settings
Water drain Drain;
see Table 100-68.
PW 6xx7