Table 100-34: Setting Options - Program Step - Spin - Miele PW 6 7 Series Technical Information

Technical Information
10. Select a program block and confirm with the OK button.
11. Select program block parameters and confirm with the OK button.
12. Select block parameter 33 ("spin") and its current program settings and
confirm with the OK button.
Acknowledgement indicator:
The top line of the display shows "Block programming –> Block parameter".
The second line shows "33. Spin" and the current program setting.
Options:
The program step "spin" in each block sets the type of spinning to be carried
out. The Profitronic M control allows the creation of a user-defined spin profile.
This consists of between 0 and 6 spin phases. Each individual spin phase is
made up of a combination of the parameters time, rhythm and speed.
Warning!
The "Automatic" spin profile is always the same and is designed for Cottons
programs. If the programmer selects "Automatic" in a Delicates program, the
load will be spun at the maximum speed for the machine model in question.
This can be up to 1200 rpm in the final spin.
Setting options - Program step - Spin:
No. Program step
33 Spin

Table 100-34: Setting Options - Program Step - Spin

1
The "Automatic" spin profile is always the same and is designed for Cottons programs. If
the programmer selects "Automatic" in a Delicates program, the load will be spun at the
maximum speed for the machine model in question. This can be up to 1200 rpm in the
final spin.
Spin phase parameter details:
Parameter
Time
Rhythm
Basic setting Setting options
No No
Automatic
User-defined
Setting options
From 0 min 0 s to 99 min 59 s in
1-s steps
No
Normal
Delicate
Gentle
86
Notes
No spin carried out
1
The control carries out an automatic
spin with 6 phases based on the
following: Pre-spin, loosening with
redistribution, spin with increasing
spin speeds 500 rpm, 850 rpm, final
spin speed, loosening. For details,
see Table 100-35.
The programmer creates a spin
cycle with 6 phases. Each individual
phase is programmed with three
settings for "Time", "Rhythm" and
"Speed". For details, see Table
100-35.
Notes
Basic setting: 0 min 0 s
Basic setting: No
Settings for rhythm & speed are interdependent.
Counterclockwise only = Spin if speed is ≥ 300
rpm and Rhythm = No is programmed. If a
rhythm other than "No" is programmed, control
automatically reduces "User-defined" speed to
70 rpm if a higher speed was set.
12 s wash, 3 s pause
5 s wash, 10 s pause
3 s wash, 27 s pause
PW 6xx7