Miele PW 6 7 Series Technical Information page 31

PW 6xx7
No. Program step
6 Temperature
7 Hysteresis
8 Warmup
9 Level 1
(dependent on
the setting for
Fill type in the
program header
for this program)
10 Intake path 1
Basic Setting options
setting
Cold Cold
15°C to 95°C
Normal Normal
Small
User-defined
Lock symbol Lock symbol
(if No has
been pro-
grammed
No
under
Heating in
this table/
block) or No
(if Yes has
been pro-
grammed
under
1°C/min to 10°C/min
Heating in
this table/
block)
Auto load 0 to 350 mm
adjustment: 0
mm
Water height 0 to 350 mm
in mm: 0 mm
Water 0 to permitted upper limit
quantity in L:
0L
Load-to- 1:0.0 kg/L, 1:0.5 kg/L,
liquor ratio in 1:1.0 kg/L, ..., to 1:20.0
kg/L: 1: 0.0 kg/L
kg/L
Automatic Automatic
User-defined: Valve 1,
valve 2, valve 3, valve 4
31
Technical Information
Notes
Water intake temperature, control does not
activate any heating.
Selection of heating temperature for this
block from 15°C to 95°C in 1°C steps.
Target temperature +0°C / -6°C in this
block.
Target temperature +3°C / - 0°C in this
block.
Values of upper and lower limits can be
modified in 1°C steps. Smallest permitted
difference between upper and lower limits
3°C. Standard settings: Hysteresis off:
+0°C and Hysteresis on: -6°C. Upper
range limits: 0°C to +3°C, lower range
limits -10°C to 0°C with smallest
permissible difference 3°C.
No has been programmed under Heating
in this table/ block.
Do not use any programmed warmup rate.
Warmup rate can be modified between
1°C/min and 10°C/min in 1°C steps in this
block.
Level 1 in mm wc (water column) can be
modified in 2 mm wc steps. The lower limit
is the minimum level for heating.
Level 1 in mm wc (water column) can be
modified in 2 mm wc steps. The lower limit
is the minimum level for heating.
Level 1 in L in 1L steps: PW 6107 max. 95
L, PW 6137 max. 120 L, PW 6167 max.
125 L, PW 6207 max. 152 L.
Level 1 as laundry:suds ratio in 0.5 kg/L
steps.
Depending on the program block and the
current water temperature in the machine,
the control selects which valves to
operate. In order to save energy the
control will attempt to achieve the desired
wash cycle temperature during the first
water intake, if possible, by operating the
cold and hot water valves alternately. For
details, see tables at Section 100-4.2.
The programmer selects No for water inlet
valves 1 to 4 or, for each valve, 1 of 11
possible options from the list K1, K2, K3,
K4, K6, KD, KH, WD, W1, W2. For details,
see tables at Section 100-4.2.