PCE Instruments PCE-360-ICA Instruction Manual page 42

equipment to be tested.
•
If possible, before connecting the voltage test leads and current probe
to the electrical equipment to be tested, take off the electrical
equipment's power.
 Connect the black voltage test alligator to the line "B".
 Connect the red voltage test alligator to the line "A".
 Connect the yellow voltage test alligator to the line "C".
 Press I1 current probe trigger to open the jaw and fully enclose the Line
"A".
 Press I2 current probe trigger to open the jaw and fully enclose the Line
"C".
5. Press "POWER" key to select (P1, Q1, S1, PF1), (P2, Q2, S2, PF2)
and (Pt, Qt, St, PFt) measured values.
6. Frequency (Hz), Phase Angle (Θ) and Power Factor (pF) measurement:
 Press "PFΘ" key to cycle shows the PF and Θ measured values.
 Press "Hz I4" key show the Hz measured value.
7. Voltage and Current THDR THDF measurement:
Please refer to section 4-1-12 "THD" key description.
8. Voltage and Current waveform harmonic measurement:
Please refer to section 4-1-25 "
9
. Power Maximum/Minimum measurement:
User Manual
CAUTION
MAG." key description
41
.