PCE Instruments PCE-360-ICA Instruction Manual page 21

Press  key to cycle through the
Minimum reading for Active power ("P" mark is blinking) with its Q, S, V, A
reading and its PF, Θ, Hz, I4 reading by press "PFΘ" and "Hz I4" keys.
Minimum reading for Reactive power ("Q" mark is blinking) with its P, S,
V, A reading and its PF, Θ, Hz, I4 reading by press "PFΘ" and "Hz I4"
keys.
Minimum reading for Apparent power ("S" mark is blinking) with its P, Q,
V, A reading and its PF, Θ, Hz, I4 reading by press "PFΘ" and "Hz I4"
keys.
c). Current reading, the " REC " mark is displayed.
 Press "MAX" key for 3 seconds to exit this mode.
11. PF Θkey: Display measured power factor or phase angle value control
key, the "PF" or "ψ" annunciator is displayed.
12. THD key: Display measured voltage or current THDF, THDR value
control key.
THDF: Total Harmonic Distortion of a waveform is compared to its
Fundamental.
THDR: Total Harmonic Distortion of a waveform is compared to the
waveforms rms value.
 Press "THD" key to enter the Voltage U1, U2 and U3 THDR and THDF
measurement mode, the "THDR" and "THDF" marks are displayed.
 Press "THD" key again to enter the Current I1, I2 and I3 measurement
mode, the "THDR" and "THDF" marks are displayed.
 Press "THD" key again to exit this mode.
User Manual