Configuration Mode; Configurable Parameters - Deif SGC 420 User Manual

6. Configuration mode

6.1 Configuration mode
To configure the controller, follow these steps:
1. Press and hold the Stop/Config
2. The display shows
3. To see the configuration, press the Stop/Config
4. The display shows
PASSWORD
5. To enter the the four digit password:
• Scroll through the digits with the Up
• Select a digit with the Start
6. To leave the Configuration mode, press and hold the Stop/Config
7. Until the configuration is saved, the display shows

6.2 Configurable parameters

6.2.1 Configurable parameters
The tables give an overview of configurable parameters.
Level 1 (table titles) and Level 2 texts are shown twice:
• DEIF Smart Connect software: Normal sentence case, for example Power on Mode.
• Controller display: Capital case in brackets, for example (POWER ON MODE)
USER MANUAL 4189341227A UK
button for at least three seconds.
button. To change the configuration, press the Start
and Down buttons.
button.
button.
button.
Page 22 of 86