Standard Spare Parts; Accessories; Minimising Wear And Preventing Damage - Stihl RMI 522.0 C Instruction Manual

1 Fold open the right clamping lever (1).
2 Remove the right wire end (2) from the
terminal block.
Close the clamping lever (1) again.
3 Fold open the left clamping lever (3).
4 Remove the left wire end (4) from the
terminal block.
Close the clamping lever (3) again.
● Close the panel ( 9.2)
● Guide the right and left wire ends out of
the docking station separately from
each other
● Fit the docking station cover (
Pull out the pegs (1), remove the docking
station (2) from the lawn with the power
supply unit connected, clean thoroughly
(with a moist cloth) and put into storage.
● Store the robotic mower together with
the docking station and the power
supply unit in the normal position and in
a dry, closed and dust-free room. Dock
the robotic mower in the docking
station. Make sure that the machine is
kept out of reach of children.
0478 131 9965 A - EN
● Protect the terminals of the perimeter
wire from environmental influences
(e.g. wrap with suitable insulating tape).
● Reinstall the docking station in the
same way as during initial installation –
in particular connect the right and left
perimeter wire ends on the correct
sides. ( 9.10)

17. Standard spare parts

Mowing blade:
9.2)
6301 702 0101

18. Accessories

– STIHL Kit S for mowing areas up to
2
500 m
– STIHL Kit L for mowing areas from
2
2,000 m – 4,000 m
– Fixing pins STIHL AFN 075
– Perimeter wire STIHL ARB 501:
Length: 500 m
Diameter: 3,4 mm
– Wire connectors STIHL ADV 010
Additional accessories are available for
the machine.
Further information is available from your
STIHL specialist dealer, on the internet
(www.stihl.com) or in the
STIHL catalogue.
For safety reasons, only
accessories approved by STIHL
may be used with the machine.
19. Minimising wear and
preventing damage
Important information on maintenance
and care of the product group
robotic mower, cordless (STIHL RMI)
STIHL assumes no liability for material or
personal damage caused by the non-
observance of information contained in the
operating instructions, in particular with
regard to safety, operation and
maintenance, or which arise through the
use of unauthorised attachment or spare
parts.
Please always observe the following
important information for the prevention of
damage or excessive wear to your STIHL
machine:
1. Wearing parts
Some parts of the STIHL machine are
2
subject to normal wear even when used
properly and must be replaced in due time
depending on type and duration of use.
These include:
– Mowing blade
– Battery
– Tyres
2. Compliance with the information in
this instruction manual
The STIHL machine must be used,
maintained and stored with the care
described in this instruction manual. Any
damage caused by non-compliance with
the safety, operating and maintenance
instructions is the sole responsibility of the
user.
This applies in particular to:
165