Storage And Winter Break; Removing The Docking Station - Stihl RMI 522.0 C Instruction Manual

● Bridge the break with the aid of a wire
connector ( 12.16). If necessary, re-
route the perimeter wire in the area of
the break.
● Reconnect the left wire end. (
● Once the wire break has been correctly
rectified, the red LED illuminates.
( 13.1)

16.8 Storage and winter break

Note the following points when storing the
robotic mower (e.g. winter break,
temporary storage):
● Charge the battery ( 15.7)
● Switch off automatic mowing (
● Activate ECO energy mode (
● Place the robotic mower in hibernation
( 11.17)
● Disconnect the power supply unit plug
from the mains
● Carefully clean all external parts of the
robotic mower and the docking station
Cover the docking station with a suitable
bucket, fasten the bucket in place.
164
● Store the robotic mower on its wheels in
a dry, closed and dust-free room. Make
sure that the machine is kept out of
reach of children.
9.10) ● Always store the robotic mower in good
operational condition.
● Keep all screws tightly fastened,
replace danger signs and warnings on
the machine that have become illegible,
check the entire machine for wear and
damage. Replace all worn or damaged
parts.
● Any machine faults must be completely
remedied prior to storage.
Never place or store objects on the
robotic mower.
11.7)
The temperature in the storage
11.10)
room should not fall below 5°C.
Resuming operation of the robotic
mower following storage for a long period:
The date and time may need to be
corrected following storage for a
long period. Appropriate selection
windows are displayed during initial
operation. If the selection windows
are not automatically displayed,
check the date and time in the
"Settings" menu and correct if
necessary. (
● Prepare the mowing area:
Remove foreign objects and cut high
grass short using a conventional lawn
mower.
● Uncover the docking station and
connect the power supply unit to the
mains supply.
● Charge the battery (
● Link the robotic mower and docking
station. (
11.10)
15.7)
9.11)
● Remove obstacles and foreign bodies
in the edge area.
Start edge following and check whether
corridors and confined areas can be
travelled on. ( 11.13)
● Check the mowing plan and change as
necessary. ( 11.7)
● Switch on automatic mowing (
● If necessary, activate Standard energy
mode ( 11.10) and switch on GPS
protection. ( 5.9)

16.9 Removing the docking station

The docking station can also be removed
if the robotic mower is to be stored for
long periods (e.g. winter break).
● Preparing the robotic mower for storage
for a long period ( 16.8)
● Disconnect the power supply unit plug
from the mains
● Remove the docking station cover and
open the panel ( 9.2)
0478 131 9965 A - EN
11.7)