Maintenance; Maintenance Schedule; Cleaning The Machine - Stihl RMI 522.0 C Instruction Manual

If the battery charge is too low, the
corresponding battery symbol appears.
In this case, place the robotic mower in the
docking station to recharge.

16. Maintenance

Risk of injury!
Carefully read the section "For your
safety" ( 6.), particularly the
subsection "Maintenance and
repairs" ( 6.9), and follow all
safety instructions exactly before
performing any maintenance or
cleaning operations on the
machine.
Activate the disabling
device prior to any
maintenance or cleaning
work. ( 5.2)
Disconnect the mains
plug before performing
any maintenance
operations on the
docking station.
Always wear gloves
when carrying out any
maintenance work,
particularly when working
on the mowing blade.
160

16.1 Maintenance schedule

The maintenance intervals are based on
the operating hours among other factors.
The relevant "Mowing hours" counter can
be called up in the "More - Information"
menu. ( 11.18)
The specified maintenance intervals must
be strictly observed.
Maintenance operations on days with
active times:
● Visually inspect the general condition of
the machine and the docking station.
● Check the display – check the current
time and the start of the next mowing
operation.
● Check the mowing area and remove
foreign bodies, etc. as required.
● Check that the battery is being charged.
( 15.7)
Weekly maintenance operations:
● Clean the machine. (
● Visually inspect the mowing blade,
blade fastening and mowing deck for
damage (notches, cracks, fractures,
etc.) and wear. ( 16.3)
Every 200 hours:
● Replace the mowing blade. (
Annual maintenance operations:
● STIHL recommends an annual
inspection by a STIHL specialist dealer
during the winter months.
Here, maintenance of the battery,
electronics and software in particular is
performed.

16.2 Cleaning the machine

Treating the machine carefully will protect
it against damage and extend its service
life.
Cleaning and maintenance position:
16.2)
16.3)
Place the machine on a firm, level and flat
surface for cleaning the top of the
machine (hood, flap). To clean the
In order for your specialist dealer to
perform all the maintenance
operations correctly, set the safety
level to "None" or give your
specialist dealer the appropriate
PIN code.
Make sure that the rotary knob is
properly installed before cleaning
as otherwise water can get into the
machine.
0478 131 9965 A - EN