Warning - Dangers Caused By Electrical Current; Battery - Stihl RMI 522.0 C Instruction Manual

6.3 Warning – dangers caused by
electrical current
Warning:
Risk of electric shock!
Particularly important for
electrical safety are an
intact power cable and
mains plug on the power
supply unit. Damaged cables,
connectors and plugs, or electric
cables that do not conform to
regulations must not be used, to
prevent any risk of electric shocks.
Therefore, check the electric cable
regularly for signs of damage or
ageing (brittleness).
Only use an original power supply unit.
The power supply unit must not be used:
– if it is damaged or worn,
– if the cables are damaged or worn.
Check the power cable in particular for
damage and ageing.
Maintenance and repair work on power
cables and power supply units must only
be performed by specially qualified
technicians.
Danger of electric shock!
Do not connect a damaged cable to the
mains and only touch a damaged cable
once it has been disconnected from the
mains.
The electric cable on the power supply unit
must not be modified (e.g. shortened). The
cable between the power supply unit and
docking station must not be extended.
The power supply unit plug must only be
connected to the docking station
electronics in dry and clean condition.
0478 131 9965 A - EN
The power supply unit and cable must not
be left on wet ground for prolonged
periods.
Danger of electric shock!
Damaged cables, connectors and plugs,
or electric cables which do not conform
with regulations may not be used.
Always ensure that the power cables used
are adequately protected by a fuse.
Detach electric cables at the plug and
socket and not by pulling on the electric
cable.
Only connect the machine to a power
supply that is protected by means of a
residual current-operated protective
device with a release current of a
maximum of 30 mA. Your electrician can
provide further information.
If the power supply unit is connected to the
mains supply outside a building, the socket
must be approved for outdoor use. Your
electrician can provide further information
about country-specific legislation.
It must be noted that current fluctuations
can damage the machine when it is
connected to a power generator.

6.4 Battery

Only use original batteries.
The battery is intended exclusively for
fixed installation in a STIHL robotic mower.
There, it is optimally protected and is
charged when the robotic mower is in the
docking station. No other charger must be
used. The use of an unsuitable charger
can result in danger due to electric shock,
overheating or escaping corrosive battery
fluid.
Never open the battery.
Do not drop the battery.
Never use a defective or deformed battery.
Store the battery out of reach of children.
Explosive hazard!
Protect the battery
against direct sunlight,
heat and fire – never
throw it into a fire.
Only use or store the battery at
temperatures from -10°C to max.
+50°C.
Protect the battery against rain
and moisture – do not immerse
in liquids.
Do not subject the battery to
microwaves or high pressure.
Never connect the battery terminals with
metallic objects (short-circuit). The battery
can be damaged through short circuits.
Keep the unused battery away from
metallic objects (e.g. nails, coins,
jewellery). Do not use metallic transport
containers – explosive and fire hazard!
Fluid may escape from the battery due to
improper use – avoid contact! In the case
of inadvertent contact, rinse with water.
Seek medical attention if the fluid comes
into contact with the eyes. Escaping
battery fluid can cause skin irritation and
burns.
Do not insert any objects in the ventilation
slots of the battery.
For further safety instructions, see
http://www.stihl.com/safety-data-sheets
107