Standard Spare Parts; Accessories; Minimising Wear And Preventing Damage - Stihl RMI 522 C Instruction Manual

● Protect the terminals of the perimeter
wire from environmental influences
(e.g. wrap with suitable insulating tape).
● Reinstall the docking station in the
same way as during initial installation –
in particular connect the right and left
perimeter wire ends on the correct
sides. ( 9.10)

17. Standard spare parts

Mowing blade:
6301 702 0101

18. Accessories

– STIHL Kit S for mowing areas up to
2
500 m
– STIHL Kit L for mowing areas from
2 2
2,000 m – 4,000 m
– Fixing pins STIHL AFN 075
– Perimeter wire STIHL ARB 501:
Length: 500 m
Diameter: 3,4 mm
– Wire connectors STIHL ADV 010
Additional accessories are available for
the machine.
Further information is available from your
STIHL specialist dealer, on the internet
(www.stihl.com) or in the
STIHL catalogue.
For safety reasons, only
accessories approved by STIHL
may be used with the machine.
0478 131 8365 C - EN
19. Minimising wear and
preventing damage
Important information on maintenance
and care of the product group
robotic mower, cordless (STIHL RMI)
STIHL assumes no liability for material or
personal damage caused by the non-
observance of information contained in the
operating instructions, in particular with
regard to safety, operation and
maintenance, or which arise through the
use of unauthorised attachment or spare
parts.
Please always observe the following
important information for the prevention of
damage or excessive wear to your STIHL
machine:
1. Wearing parts
Some parts of the STIHL machine are
subject to normal wear even when used
properly and must be replaced in due time
depending on type and duration of use.
These include:
– Mowing blade
– Battery
– Tyres
2. Compliance with the information in
this instruction manual
The STIHL machine must be used,
maintained and stored with the care
described in this instruction manual. Any
damage caused by non-compliance with
the safety, operating and maintenance
instructions is the sole responsibility of the
user.
This applies in particular to:
– Incorrect handling of the battery
(charging, storage)
– Incorrect electrical connection (voltage)
– Product modifications not approved by
STIHL
– Use of tools or accessories which are
not approved or suitable for the
machine, or are of inferior quality
– Improper use of the product
– Use of the product for sporting or
competitive events
– Resultant damage due to continued use
of the product with defective
components.
3. Maintenance operations
All operations listed in the section
"Maintenance" must be performed
regularly.
If these maintenance operations cannot be
carried out by the user, a specialist dealer
must be commissioned to perform them.
STIHL recommends that you have
maintenance operations and repairs
performed exclusively by a STIHL
specialist dealer.
STIHL specialist dealers regularly attend
training courses and are provided with
technical information.
If these operations are neglected, faults
may arise which are the responsibility of
the user.
These include:
– damage to the machine as a result of
inadequate or incorrect cleaning,
– corrosive and other resultant damage
caused by incorrect storage,
71