19
Starter/Generator
9.
Maintain tension and tighten the adjustment nut (1) to 15 to 18 ft·lb (20 to 24.5 N·m). Tighten the pivot nuts (2) to
20 to 25 ft·lb (27 to 34 N·m) (Figure 19-23, Page 19-18).
2997C
Figure 19-23 Starter/Generator Mounting Hardware
10.
Remove the belt tension tool.
11.
Confirm proper belt tension with a final measurement.
12.
Connect the spark plug wire.
BELT TENSION TOOL MODIFICATION
1.
Remove the nut and J-bolt from the bracket.
2.
Grind or cut 3/8 to 1/2 inch (9.5 to 12.7 mm) (A) from bracket as shown to increase the effective length of
the J-bolt (Figure 19-24, Page 19-18).
2726B
Figure 19-24 Belt Tension Tool Modification (If Necessary)
3.
Install the J-bolt and nut into the bracket.
Page 19-18
2019 Carryall 550 Maintenance and Service Manual
Installation
GASOLINE VEHICLE - ELECTRICAL
COMPONENTS