Table of Contents
Advertisement
GASOLINE VEHICLE - CLUTCHES
2961C
2.
Slide the acetal washer (3) and moveable sheave (4) onto the fixed sheave (5) (Figure 23-20, Page 23-17).
2961D
3.
Place the end of the spring (6) into the hole in the moveable sheave (9).
4.
Install the key (7) into the keyway of the fixed sheave shaft.
5.
Holding the cam (8) in position for assembly on the shaft, install the other end of the spring into the center spring
hole of the cam. Rotate the cam until the keyway is aligned with the key on the fixed sheave, and then start the
cam onto the shaft approximately 1/4 to 3/8 in. (6.3 to 9.5 mm).
6.
With the clutch loosely assembled, set the edge of the clutch body (9) on a clean, flat surface (Figure 23-21,
Page 23-18).
Figure 23-19 Drive Button Installation
Figure 23-20 Driven Clutch Assembly
2019 Carryall 550 Maintenance and Service Manual
23
Driven Clutch
Page 23-17
Advertisement
Table of Contents
Troubleshooting
