Club Car Carryall 550 2019 Maintenance And Service Manual page 536

Install Oil Fill Tube
Details
A Oil Fill Tube
C Bracket Screw
1. If oil fi ll tube was removed from closure plate, apply
a small amount of Loctite
end of tube, then press into closure plate until tube
bead seats in closure plate. Tube should be parallel
to closure plate PTO face.
2. Place bracket over tube and secure with bracket
screw. Tighten screw until bracket is tight all around
tube; then torque to 5.4 N·m (48 in. lb.).
17 690 15 Rev. --
C
B
A
B Oil Fill Tube Bracket
620 (or equivalent) to
® TM
KohlerEngines.com
Install Closure Plate
Torque Sequence
6
4
2
1. Check to make sure sealing surfaces of crankcase
and closure plate are clean and free of nicks/burrs.
2. Install two dowel pins into locations shown in
crankcase. Install new closure plate gasket (dry)
onto dowel pins.
3. Install closure plate to crankcase. Carefully seat
ends of camshaft and balance shaft into their mating
bearings.
4. Install screws securing closure plate to crankcase.
Torque screws in sequence shown to 24 N·m
(212 in. lb.).
Reassembly
1
5
3
7
73