Table of Contents
Advertisement
GASOLINE VEHICLE - FUEL SYSTEM
1
539
Figure 21-1 Accelerator Rod
Accelerator Rod Installation and Adjustment
1.
Before installing the accelerator rod, adjust accelerator pedal position. See Pedal Group Adjustment –
Gasoline Vehicles in the Accelerator and Brake Pedal Group Section.
2.
Install the ball joint (1) on the ball stud (2) at the accelerator pedal (Figure 21-1, Page 21-3).
3.
Access the engine compartment.
4.
Remove the electrical component box screw and cover (Figure 21-3, Page 21-4).
5.
Adjust length of accelerator rod. With the ball joint jam nuts (3) loose (Figure 21-1, Page 21-3), adjust the length
of the rod to obtain an accelerator cable cam position of 7° as shown (Figure 21-3, Page 21-4). See following
CAUTION.
CAUTION
• Be sure that approximately an equal number of threads are exposed at each end of the accelerator rod.
6.
Install the accelerator rod on the bell crank ball joint on the electrical component box (Figure 21-2, Page 21-3).
See following CAUTION.
CAUTION
• Inspect the limit switches inside the electrical component box. If a limit switch lever is bent, replace
the switch.
2
3
1345
Figure 21-2 Accelerator Rod – Pull Spring Release to
2019 Carryall 550 Maintenance and Service Manual
Engine Control Linkages
Attach (Bottom View)
21
Page 21-3
Advertisement
Table of Contents
Troubleshooting
